CG1-2A H Beam cutter
- 8 -
Cutting position: preheating flame and cutting oxygen turn on and cutting begins.
State of close State of preheat State of cutting
2) Application introduction
Pull quick distributor switch knob in the preheating position, ignition and adjust flame.
Adjust valve to get best preheating flame. According to recent pressure, pull the knob in the
cutting position and adjust oxygen flow when preheating flame is on. After these operations,
pull the knob in the off position, repeat adjusting from preheating flame to cutting oxygen
until be sure that flame is on normally. If pressure verifies, adjusting is needed again.
3) Quadruple switch
Sub switch is to control running direction of web plate motor and wing plate motor;
interlocks with cutting oxygen. There are four arrows on the control panel. When operating
bar of quadruple switch is pulled on the arrow side, it is running machine. Operating bar of
switch returns to original position, machine stops running and cutting oxygen turns off.
4)Fast-moving switch
Switch is in the center of control panel. When
press the switch, web plate motor and wing
plate motor run at maximum speed
(about750MM/MIN). Sub function is convenient
for torch going forward and back quickly. When
handle of quick distributor is in the cutting
position, cutting oxygen stops supplying in the
work.
5) Pilot wheel for transverse:
Tip is convenient to align mark line.
Содержание CG1-2
Страница 1: ......
