DBS3900 LampSite
Installation Guide
15 Appendix
Issue 08 (2016-05-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
281
Figure 15-12
Binding the label
(1): Cable tie
(2): Label
(3): Cable
You should use an outdoor cable tie with a appropriate width in outdoor scenarios (the default is black
cable tie with 3.6 mm or 0.14 in. width).
The position for banding the label is recommended from 20 mm to 100 mm (0.79 in. to
3.94 in.) away from the cable connector. Ensure the front of the label facing you and not
be covered.
In case of both ports of the cable connected have different silkscreen, both ends of the
cable should bind the port label on the two ends of cable. For example, in dual BTSs
cascading scenarios, one end of the cascading FE/GE cable is connected to
LAN1
port
on BTS0, and the other end connected to
WAN
port on BTS1. At this point, both ends of
the cable should band two labels
Micro BTS0 LAN1
and
Micro BTS1 WAN
. As shown
in Figure 15-13, the distance between the two labels is recommended from 10 mm to 20
mm (0.39 in. to 0.79 in.).
Figure 15-13
Positions for banding labels
You may change the positions for attaching labels in actual situations. For example, you can bind a label
where the cable is bent.
Step 2
Tighten the cable tie, securing the label on the cable, and then cut off the extra part of the
cable tie, as shown in Figure 15-14.
