Section 2 Software User's Guide
2.1 Installing the software
2.2 Setting the RJ45 module of the HE2400 wireless base station
6
Installation and Instruction
2
Plug the HE2400 into a 12V power supply, plug in the ethernet cable, open Lanconfig program in the
folder, and a pop-up interface will be shown as below:
(1) Click [Search Modules] to search for devices. The names and IP addresses of all the DTU connected to
the LAN will be displayed in the right of the window.
Note: LanConfig software uses UDP broadcast protocol for module search, please make sure that the
software is not blocked by firewall or antivirus software.
(2) Select the serial number of the found HE2400 DTU and double-click to obtain the attributes.
(3) Name: instrument name, can be modified according to actual needs. (Note: The factory setting is the
instrument’s serial number)
(4) Work Model: Set to TCP Client mode.
(5) Baud Rate: set to 115, 200
(6) DHCP Mode: select Disable to turn it off. It is recommended to choose a fixed IP address to ensure
network stability.
(1)Put the Monitor software CD into the CD-ROM drive, and install ToMonitor_V8 software to the computer
hard disk.(Note: It is recommended NOT to install it on the drive C to prevent the d losing data caused by
operating system crashing).
(2)Open the installation folder and find the ToMonitor icon.
(3)This instrument may use HE2400 or HE2410 DTU to upload data. In case of HE2410, you need to
install the driver. Find the USB_Driver directory on the CD-ROM and click the Setup.exe program.
A dialog box pops up and click the "INSTALL" button. It will take a while, to install the driver to the
computer. Driver is not needed for HE2400.