2.2.1
-
Read and Configure the Logger's Settings
1. Turn on and Insert the data logger to the computer
¹
.
2. Start LogPro software on the PC.
3. From the toolbar select Connect.
4. Load & Read the logger’s current settings.
5. Configure the new settings.
6. Sync the settings & time. (The PC time will be synchronized to the logger
as well.) .
7. From the toolbar select disconnect.
8. Sync the Computer's Data & Time to the Data Logger.
9. Unplug the logger from the computer, and then the logger is in Standby mode.
7
4
5
3
8
6
1. The Windows® operating system cannot handle USB devices being unplugged and plugged back too fast. When
unplugging the logger, wait for about 5 seconds before plugging it in again. If you unplug and plug back a device
too quickly, the computer may stop recognizing any USB devices on that port. If this happens
,
you will have to
restart the computer. This is a Windows® USB problem and is not related to LogPro.
Installation and Instruction
2
5
Section
2.2 - How to Read and Configure the Logger
