HTW PURE LIGHT UV HTWS026PLUV, Руководство по установке

Страница: 30 / 88

Indoor Unit Installation
The tube may be connected in several directions as below shown Figures.
1. Connecting right back tube (similar to right lower tube)
(Optional, Refer to Fig.7)
•
Pull out the tubing from bottom of the chassis; and
connect the drainpipe. Strap the joint of tubing re -
liably.
•
Lead the connecting wire to the indoor unit (Do not
connect to the power).
•
Strap together the tubes, discharge pipe and con-
necting wire with
•
adhesive tape. The discharge pipe is put at the be-
low.
•
Remove the board which is on the chassis.
•
Check if the connections are reliable.
Mount the indoor unit on the two hooks at the upper
part of installation board.
2. Connecting left back tube (similar to left lower tube). (Optional, Refer to Fig9)
•
Move the discharge tube to the left side, and discharge cap to the right side.
•
Fix the tubes in the slot of the indoor unit with the fix clamp.
•
The following mounting steps are the same as those in “1. Connecting right back
tube.”
Pipeline
Drain pipe
Fig.6
Units connecting wires
Fixed clamp
F ig.9
Wall
Fig.8
Installation
board
Drain hose
Fig.7
Rightward
Rightback
Downward
Fixed clamp
Leftback
Drain hose
Leftward
28