|
51
Temperature Switch TS 2-1000
50
| Mode „Manuell“ (manual)
12 mOde “manuell” (manual)
In this mode all for relays ((REL1, REL2, ALARM1, ALARM2)
can be switched manually on and off.
InpuT mOde “manuell”
The following menu points are shown in this mode:
Relay 1
,
Relay 2
2
Relay Alarm 1
2
Relay Alarm 2
2
Start Mode
+
The status of the relay can be set by using the buttons
pq
.
The mode is started by confirming the menu point “Start Mode”.
mOde menu “manuell” (manual)
The following menu points are shown in this mode:
Name of the mode
,
Relay 1
2
Relay 2
2
Relay Alarm 1
2
Relay Alarm 2
+
13 mOde “sensOraBgleIch”
(calIBraTIng The sensOr)
This menu allows the calibration of the sensors
and the connecting cables to the sensors.
Sensor 1 R-Offset
,
Sensor 1 T-Offset
2
Sensor 2 R-Offset
2
Sensor 2 T-Offset
+
The parameters have the following meanings:
sensor 1 r-Offset:
This input allows the offset correction of the resistance
within the wire leading to sensor 1.
Adjustable value:
0 – 50Ω
sensor 1 T-Offset:
This input allows the offset correction for sensor 1.
This value is added/deducted from the shown temperature value T1.
Adjustable value:
–50°C to +50°C
sensor 2 r-Offset:
This input allows the offset correction of the resistance
within the wire leading to sensor 2.
Adjustable value:
0 – 50Ω
sensor 2 T-Offset:
This input allows the offset correction for sensor 2.
This value is added/deducted from the shown temperature value T2.
Adjustable value:
–50°C to +50°C
14 mOde “zurückseTzen” (reseT)
In this mode all input parameters can be reset to factory settings.
