6
Input Level
MIN MAX
40HZ 180HZ
FREQUENCY (XO)
Phase
0 180
Speaker
Level
Outputs
Speaker
Level
Inputs
+
_
+
_
L
R
LFE-XO Bypassed
LFE-XO Active
Line In
Line Out
Left Right
40 Hz 80 Hz
ON AUTO
POWER
OFF
POWER
LIGHT
AC ~ 120V/60HZ
On
Off
Fuse T5AL/250V
POWER CONSUMPTION: 330W
MODEL : SA-150
Level TWO Powered Subwoofer
AVIS:RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
CAUTION
Ri
RISK OF ELECRIC SHOCK
DO NOT OPEN
Variable Subwoofer Level Control
allows you to quickly balance the
subwoofer volume with the other
speakers. Once you set this, leave
it alone. Subwoofer level will rise
and fall with the system.
Crossover Frequency
Control
determines the
upper Frequency Limit to
be played by the Powered
Subwoofer.
5-Way Binding Posts
for solid connections with
speaker cable when using
Speaker Level Inputs & Outputs.
Phase Control
retains
phase coherency between
the Subwoofer and system
speakers.
A Pair of gold-plated
stereo outputs
are available to pass along
the signals received in
the two stereo inputs.
Low Frequency Effect
(LFE) Inputs:
You can
choose to bypass the
Internal Crossover (XO)
or
use the Active Input to
dial in your preferred
Crossover point.
IEC Socket
for connecting the
removable power cord.
An External Fuse
can be replaced in the
event of an unexpected
electrical shock to the
unit.
40 Hz or 80 Hz Hi-Pass Filter
for the Speaker -Level Outputs
ONLY - decide how much
Mid-Low Frequencies are sent
to your Front Left and Right
Speakers.
Power mode switch
determines if the Subwoofer
Amplifier is always on (ON),
turns on when an input
signal is sensed
(Auto-Power), or OFF.
Power Light
NO Light = OFF
RED Light = STANDBY
GREEN Light = ON
A pair of gold-plated
stereo inputs
are available
for Line Level Signals.
!
Hooking Up Your Speakers
HTD speakers utilize quality gold-plated, five-way binding posts in conjunction with a complex high pass and low
pass crossover. The gold-plated binding posts ensure an efficient transfer of signal and power from any standard
type of cable or wire connector, including bare wire. For bare wire or pin-type connectors, simply thread the wire or
pin through the hole in the threaded post near the base of the binding post, then tighten the red or black collar down
against it. Spade connectors can be fitted around the threaded post near the base. Again, simply tighten the red or
black collar against it to maintain the connection. Individual or paired banana plugs can be inserted directly into the
holes at the mouth of the collar with the binding posts already tightened down.
When connecting the speakers, it is very important to retain the correct polarity. This means that the wire attached
to the +, red, or positive terminal on one component must be attached to the +, red, or positive terminal on the
corresponding component’s speaker output terminals. Similarly, the -, black, or negative terminals must connect to
the respective -, black, or negative terminals. We recommend using 14 gauge oxygen-free cable, although the binding
posts can accept up to 10 gauge.
Powered Subwoofer Panel Markings and Controls
