HTC confidential
© 2006, HTC CORPORATION. ALL RIGHTS RESERVED. TOTAL
58
CONT.ON. 43 PAGE NO.
42
7.2 Main unit inspection
7.3.1 System assembly inspection :
-Exposure of substratum is not acceptable for peeling. (Area 4 is included)If not exposure of
substratum, please checked by SPEC. of dot or scratch. (Area 4 is not included)
-Logo may not have blurred or double print., the peeling on logo is not acceptable.
-The character printing of main unit does not allow bad printing,scratch,dirty, lacquer
peeling ,dark/white dot on it)
- Camera lens dot, particle D
≦
0.25mm
；
burr
≦1
.5mm ,
W≦0
.2mm ,
1. (Gap inspection )
Description
A c c e p t c r i t e r i a
L e v e l
1.
Status of main unit assembly.
Defective assembly and deformed shape were nor allowed.
Minor
2.
Gap between touch panel and bezel.
Gap between touch panel and bezel < 0.7 mm
(Skip corner and Enter the material to click)
Minor
3.
Gap between upper / lower slid parts.
Gap between upper / lower slid parts < 1..0 mm
Minor
4.
Qwerty key Gap and
around Gap
Between key
Gap<0.35 mm,
Edge of key and C-part Gap
<0.4 mm
Minor
5.
Gap between navigation key and
AP keys assembly.
(gap) <0.35 mm
Key stuck are not allowed.
Minor
6.
Gap around power button, record
button, volume key, camera button
(gap) <0.35 mm
Key stuck are not allowed
Minor
7. Stylus
Stylus assembly protruding, loose, missing, falling
and deformed is not allowed.
Minor
8.
Gap between battery cover and
main unit.
D,E parts(gap) <0.50 mm
Minor
