Usage
HTC GL 40 D
16
2.0
3. Cut or slice off the bag between the ties, see Figure 4-5, page
Figure 4-5. Cut or slice off the bag.
4. Discard the full bag.
5. Pull down the roll of bags to the recommended length, around 500 mm.
4.4.2
Fitting Longopac
When fitting Longopac bags, it is recommended that the dust extractor is in the
operating position, see Figure 4-2, page
1. Loosen the clip around the bottom cone.
2. Lift the Longopac holder slightly and turn it until it comes loose from its fitting.
Tip!
The Longopac holder is attached by a bayonet fitting to the dust
extractor.
3. Put the new Longopac roll in place in the holder.
4. Push the roll down into the intended slot.
5. Cut off the band that is around the roll on delivery.
