HTB500
EN – 8
6. MAINTENANCE
6.1. GENERAL INFORMATION
1. While using and storing the instrument, carefully observe the recommendations listed
in this manual in order to prevent possible damage or danger during use.
2. Do not use the instrument in environments with high humidity levels or high
temperatures. Do not expose to direct sunlight.
3. Always switch off the instrument after use.
6.2. BATTERY RECHARGE
When the display shows symbol
“
”
, it is necessary to replace the battery.
CAUTION
Only expert technicians should perform this operation. Before carrying out
this operation, make sure you have removed the probe from the input
terminal.
1. Switch off the instrument and remove the probe from the input terminal.
2. Connect the provided USB cable to the USB input of the instrument (see Fig. 2
–
part 3)
and the other end of the cable to a USB port of the PC, regularly switched on.
3. The recharging process starts and the following icons
“
”
are shown in
a sequence on the display:
4. At the end of the recharging process, the icon
“
”
appears fixed on the display.
5. When necessary, replace the battery. Do not discard the used one into the
environment. Use the relevant containers for battery disposal.
6.3. CLEANING THE INSTRUMENT
Use a soft and dry cloth to clean the instrument. Never use wet cloths, solvents, water, etc.
6.4. END OF LIFE
WARNING
: this symbol found on the instrument indicates that the appliance, its
accessories and the battery must be collected separately and correctly disposed
of.