Operating & Safety Guide 621
Operating & Safety Guide 621
621/03
621/03
©HSS Hire Service Group Ltd 2012 No. 621/03
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.com
…any comments?
If you have any suggestions to enable us to improve the
information within this guide please e-mail your comments or
write to the Safety Guide Manager at the address below
e-mail: [email protected]
... have you been trained
The law requires that personnel using this type of equipment in
the workplace must be competent and qualified to do so.
Training is available at HSS Training
0845 766 7799
Never use the equipment for anything other than its
intended purpose. If it will not do what you want, assume
you have the wrong equipment for the job. Contact HSS
Hire for advice.
Handle the equipment with care. Avoid dropping it,
knocking it or otherwise exposing it to damage.
Never expose the equipment to excessive moisture,
dust or dangerous / corrosive chemicals.
Keep the equipment clean. You will find this less of a
chore if you clean it regularly, rather than waiting until the
end of the hire period.
If the RCD trips, turn off the power, unplug everything
connected to it and turn the power back on - reset the RCD.
If it trips again, contact HSS Hire for advice.
Switch OFF and unplug all electrical equipment
connected to the lead / box.
Unplug all cables and dust them down with a soft cloth.
Finally, neatly coil the cables ready for return to HSS Hire.
Code 40970/72/91/92/93 40980
A safety essential for power tools
& electrical equipment, reducing
the risk of electrical shock
EQUIPMENT CARE
NOTE
If you find
Cuts, abrasions or severe kinks in any lead.
Cracked, chipped or otherwise damaged plugs.
Water or other liquids that may have penetrated
plugs, casings or any electrical connection –
including the RCD itself.
Return the equipment to HSS Hire.
FINISHING OFF
Residual Current
Device
(RCD)
Residual Current
Device
(RCD)
