IMPORTANT SAFETY NOTES
Do not shred envelopes or labels with a sticky substance like glue. Do not
shred wet paper, carbon paper or vinyl bags. The shred will stick in the
cutters and may cause paper jams or lower shredding performance.
Empty the wastebasket regularly to prevent paper jams.
Do not operate if the power cord appears damaged. Do not alter this unit or
cord in any way.
Do not place this shredder near water or any heat source. Keep 6 inches
away from wall.
Do not use any oil or lubricants not clearly specified for shredder use in or
around this unit. Some agents may combust causing serious injury.
If an extension cord is used, make sure that the total ampere ratings of the
products plugged into the extension cord do not exceed the extension cord
ampere rating, and that the total of all products plugged into the wall outlet
does not exceed 15 amps.
This shredder should be used only with an operator in attendance. Keep
shredder in the ON/OFF position and unplug from the AC outlet when not in
use for an extended period of time.
Avoid exposing the shredder to direct sunlight.
TECHNICAL DATA
Part Number:
HSM1030
Security Level:
3
Shred Size:
5/32" x 1 3/8"
(4 x 35mm)(cross cut)
Throat:
9” (228.6 mm)
Maximum Capacity:
17 sheets
Shred Bin Capacity:
7.1 gallons (26,8 liters)
Voltage:
115 V/60 Hz
Noise level:
58 dB
Weight:
35.2 lbs. (16 kg)
Continuous run time
Note: In order to maintain the machine, we suggest using it for 120 minutes on and
30 minutes off.
INSTALLATION:
-Unpack and set the machine upright on level surface.
-Make sure the waste bin is properly inserted into the shredder cabinet.
-
Plug in the machine. See “TECHNICAL DATA” for necessary precautions.
-The outlet should be installed near the equipment and be easily accessible.
The main connection at the machine must be freely accessible.
MAINTENANCE INSTRUCTIONS
To ensure proper operation and function, periodic oiling of the cutting system is
required. Failure to oil your cutting system could result in reduced sheet capacity
performance, excess noise, paper jams and possible machine failure.
Run the machine in reverse after every 15-30 minutes of continuous use while
applying a thin strip of oil to the cutting head.
-Squeeze the lubricant across the full width of the cutters.
-Clean the shredder housing using a soft cloth dampened with a mild solution of
detergent (such as dish washing liquid) and warm water. DO NOT use chemical
cleaners or solvents.
CLEANING PHOTO EYE SENSORS
1. Unplug your machine
– for your safety
2. Lift CD Flap on machine (If no flap installed, disregard this line and continue
on) Note: In the center of the paper slot, you should see (2) transparent
squares - one on either side of the slot.
3. Use compressed air or take a dry tissue or paper towel and wipe back and
forth a few times just to dust that area off
4. Replace flap if necessary
5. Plug machine back in
Turn off and unplug the shredder before moving, emptying the waste
bin, or if the shredder will not be used for a long period of time.
Keep children and pets away from shredder.
Do not place fingers, hands or any foreign objects in the feed slot.
Serious injury may result.
Keep ties, jewelry, hair and loose clothing away from the feed slot.
Serious injury may result.
Do not use canned air on shredder. Never use aerosol, petroleum
based or other flammable products on or near
shredder.
Do not exceed the recommended paper capacity of 17 sheets. One
folded sheet of paper equals 2 sheets. An occasional paper clip or
metal staple is allowed.
Shred only one credit card at a time.
Shred only one CD, DVD at a time.