HSD ES327, Руководство по сборке

Страница: 10 / 122

1 Preliminary Information
10
HSD S.p.A. © - 0101h03a.fm100713
1.4 Risks associated with the use of the product
The manufacturer is not aware and cannot be aware of how the product will be installed.
Consequently, the installer or final user must perform a risk analysis relating specifically to the type
of installation and the methods adopted.
It is nevertheless the responsibility of the installer to ensure that there is adequate protection
against risks of accidental contact with moving parts.
The installer and user must also take into account the possible presence of other types of risk, in
particular that deriving from the entry of foreign bodies and the use of explosive, flammable, toxic
or hot gases.
Consideration should also be given to risks inherent to maintenance operations, which must be
carried out under conditions of maximum safety by ensuring that the product is isolated and at a
complete standstill.
An overall risk analysis must be carried out on the completed machine on which the
manufacturer's product will be installed. A conformity declaration must then be issued in line with
Appendix IIA of directive 2006/42/EC and its subsequent amendments.
The product must not be put into service until the machine in which it has been incorporated has
been made to comply with the requirements of Directive 2006/42/EC and its subsequent
amendments.
1.4.1 Risks associated with improper handling and/or use
It is absolutely forbidden to bypass, remove, modify or render inoperative any safety devices,
controls or guards protecting individual parts or the product as a whole.

Never place hands, arms or any other parts of the body near to moving parts.

The product must not be used in environments where there is an explosion risk .

The elimination of faults or anomalies in the operation of the product or modifications to the
type of operation or installation must not be carried out by unauthorised personnel.

On completion of any extraordinary maintenance involving the removal of guards, barriers or
other safety devices, these must be replaced before starting the product, making sure that
they are positioned correctly and in full working order.

All guards and safety devices must be maintained efficient and in perfect condition. Warning
and danger signs and symbols must be clearly legible and must never be removed.

When performing troubleshooting operation on the product, take all the necessary precautions
described in the Instruction Manual to prevent damage or injury.

Remember to tighten all screws, nuts and locking rings of each mechanical component that
has been adjusted or set-up.

Before starting the product, make sure that all the safety devices are installed and in perfect
working order. If this is not the case, under no circumstances must the product be started,
instead inform the works safety manager or the department head.

The operator must be provided with Personal Protection Equipment (PPE) as provided for by
current legislation. Loose bulky clothing and accessories (ties, wide sleeves, etc.) must not be
worn.