
5. Manual Tuning Mode
Manual tuning is aimed for adjust frequency deviation, power, sensitivity, and
noise elimination, etc.
Note: Before enter the manual tuning mode, read the radio settings into the
computer first using the programming software, and then go to program manual,
modulation mode, choose manual tuning mode, close current widow and write
in modulated setting from the computer to the radio. This will enable you to
enter the manual tuning mode.
(1) To enter the mode:
Press [PTT+Moni] to turn on the power, keep it in 2 seconds until LED flashes
twice in green, release to get into manual tuning mode.
No.
Items
CH No.
Turning up procedure
Work frequency
a
、
Switch to channel 1, power connected to 7.5V
b
、
Switch to channel 1, Power connected to 7.5V ,
Power on via Pressing [PTT] and [Middle key],
red light on
1
7.5V Voltage
calibration
1
C
、
Switch to Channel 16 in 4seconds,Calibration
successful when you hear long "Di"
Switch to channel 1 Press [PTT+MONI] to turn on
Green light on
b
、
switch to channel 16 in 3seconds
2
Manual turn up
Switch on/off
5
c
、
Press[PTT] or [MONI] for adjust
,
long
”
di
”
sound is on
short
“
di
”
sound is off
a
、
Switch to channel 8 Press [PTT+MONI] to turn on
Green light on
3
Initialization 8
b
、
switch to channel 16 in 3seconds.green light off
a
、
Switch to channel 10 Press [PTT+MONI] to turn on
Green light on
4
Aging program
10
b
、
switch to channel 16 in 3seconds.green light off
red light on ,enter to aging program
a
、
Switch to channel 11 Press [PTT+MONI] to turn on
Green light on
b
、
switch to channel 16 in 3seconds.green light off
c
、
Switch to
15
Tx Frequency
Deviation
Press PTT increasing
Press MONI decreasing
14
CTCSS
Deviation
Press PTT increasing
Press MONI decreasing
5
Communication setting
11
13
CDCSS
deviation
Press PTT increasing
Press MONI decreasing