HQRP GXV630R, Инструкция по эксплуатации

Страница: 31 / 37

MAINTENANCE
3-4
OIL FILTER REPLACEMENT
Drain the engine oil.
Remove the oil filter (1) using the special tool (2).
Apply a light coat of engine oil to the O-ring (3) of the
new oil filter.
Install the new oil filter and tighten to the specified
torque.
Fill with recommended oil to the upper level mark of the
oil level gauge (page 3-3).
Start the engine and warm up for 1 to 2 minutes.
Check the oil level and if necessary, fill with the
recommended oil to the upper mark of the oil level
gauge (page 3-3).
AIR CLEANER CHECK/CLEANING
A dirty air filter will restrict air flow to the carburetor,
reducing engine performance. If the engine is operated
in dusty areas, clean the air cleaner more often than
specified in the MAINTENANCE SCHEDULE.
Operating the engine without the air filters or with the
filter installed loosely will allow dirt to enter the engine,
causing rapid engine wear. Install the air filters
securely.
Remove the air cleaner cover (1).
Remove the outer filter (Foam) (2) from the element
holder (3).
Remove the element holder and inner filter (Paper) (4)
from the air cleaner case (5).Carefully check both filters
for holes or tears, and replace if damaged.
Clean the outer filter (1) in warm soapy water (2), rinse
and allow to dry thoroughly, or clean with a non-
flammable solvent (2) and allow to dry thoroughly. Dip
the filter in clean engine oil (3) and squeeze out all the
excess oil. Excess oil will restrict air flow through the
foam element and may cause the engine to smoke at
startup.
TOOLS:
Oil filter wrench 65 mm (2) 07HAA-PJ70101 or
07AAA-PLCA100
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
(2)
(1)
(3)
(1)
(2)
(1)
(4)
(3)
(3)
(5)
(5)
(2)
(1)
(3)
Squeeze
and dry
Squeeze thoroughly
62Z6P000.book 4 ページ ２００９年７月９日 木曜日 午後１時３５分