HQ Power HQSM10007, Руководство пользователя

Страница: 5 / 38

HQSM10007
V. 02 – 11/04/2017 5 ©Velleman nv
5.2 Overhead Installation
•
When hung, the device must always be secured with a secondary attachment e.g. a
safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced.
Have a qualified technician check the device once a year and once before you bring it
into service.
•
Overhead mounting requires extensive experience: calculating workload limits,
determining the installation material to be used… Have the material and the device
itself checked regularly. Do not attempt to install the device yourself if you lack these
qualifications as improper installation may result in injuries.
•
For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through
the centre of the (folded) bracket.
5.3 Connection
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. All devices must be powered
directly off a grounded switched circuit. Do not connect to a dimmer pack.
•
The installation has to be approved by an expert before the device is taken into
service.
6. Operation
6.1 Preparing Your Device
1. Make sure the device is switched off.
2. Remove the cap from the tank and remove tank from its compartment.
3. Verify that the plastic hoses attached to the cap are in place and in good condition.
4. Pour fluid into the tank, replace the tank into its compartment and close. Make sure the plastic hose
entering the smoke machine from the fluid tank is not bent or kinked.
5. Connect the device to the mains, switch it on and let it warm up.
6.2 Using Your Device
1. Prepare your device as described above.
2. Press the manual activation button to output fog/smoke. Release the button to stop the fog/smoke
output.
6.3 DMX Configuration
To set the device in DMX mode:
1. Connect a DMX cable to the DMX input of the smoke machine and the DMX output of a controller
(not included).
2. Prepare your device (see above).
3. Set your DMX address using the DIP switches.
channel to from function
1
output
000 005 0 %
006 255 5-100 %
•
Make sure that the starting address of the interconnected devices do not overlap.