Warning:
Lamp failure of incandescent globes
mounted in the upright position, such as
candle globes, may damage the time delay
switch. This is caused by the broken filament
falling down and shorting out the globe. It is
therefore recommended that incandescent
globes be mounted in the normal position.
3 Operation
Warranty
HPM Cat XLTD770/1 and TD170/1 are warranted as
here and after appears, against faulty material and/or
workmanship for a period of one year from the day
of purchase. The obligation of the manufacturer
under this warranty is limited to servicing and
replacing defective parts when the unit is returned
to the authorised place of purchase. To obtain
warranty repair, the purchase receipt should be
returned with the product.
This warranty becomes void on any unit which
has been tampered with or damaged by accident,
short circuited, loaded beyond rating or damaged
otherwise by improper operation. The warranty is
also conditional on the unit being installed by a
licensed electrical contractor. All other warranties,
whether expressed or implied, and whether arising
by operation of law or otherwise are hereby excluded.
Customer Service & Technical Support
HPM Legrand - Australia
Tel 1300 369 777
www.hpm.com.au
HPM Legrand - NZ
Tel 0800 476 009
www.hpm.co.nz
Pressing the push button turns the light on. The timing cycle commences when the button is released. If the button is pressed again
before the timing cycle is completed, the timing cycle will re-commence from the moment the button is released. The unit will turn itself
off when the timing cycle is completed.
The XLTD770/1 & TD170/1 Time Delay Switches are solid state devices, so there is still 240V present at the load even when the unit is
switched off.
Therefore, we recommend that power be switched off at the circuit breaker before replacing faulty lamps.
4 Wiring Instructions
Cat XLTD770/1
OR TD170/1
Time Selection Switch
(1, 3 or 10 Minutes)
Remote push buttons
Cat NX770M (Optional)
LOOP
ACTIVE
LOAD
LOAD
NEUTRAL
ACTIVE
5 IMPORTANT SAFETY WARNING
SWITCHES, POWERPOINTS AND OTHER
FIXED WIRED PRODUCTS MUST BE INSTALLED
BY AN ELECTRICAL CONTRACTOR OR
SIMILARLY QUALIFIED PERSON
✓
✗
23391A
