HPE Synergy 12000 Frame, Руководство по техническому обслуживанию и ремонту

Страница: 72 / 141

Removing and replacing a power supply Removing and replacing a power supply
For power specifications and calculators to determine electrical and heat loading for HPE Synergy, see the HPE Synergy Planning Tool
on the Hewlett Packard Enterprise website (https://dcia.itcs.hpe.com/
https://dcia.itcs.hpe.com/).
WARNING: WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
WARNING: WARNING:
To reduce the risk of electric shock or damage to the equipment, do not connect the power cord
to the power supply until the power supply is installed.
Install power supply blanks in any unused power supply bays.
Procedure Procedure
1. If using zip ties, unfasten the reusable zip tie. Retain for replacement.
2. Disconnect the power cord from the power supply.
3. Squeeze the handle, and then pull the power supply from the frame.
CAUTION: CAUTION:
To prevent improper cooling and thermal damage, do not operate the frame unless all device bays are populated
with either a component or a blank.
To replace the component, align and slide the power supply into the bay until it locks into place.
Removing and replacing a power supply 72