• Two power cables
• Two network cables
2.
Verify that you received the storage enclosure
contents.
• Storage enclosure
• Rail kit
• Power cables
◦ StoreOnce 5200: two cables
◦ StoreOnce 5250 and 5650: four cables
• HD SAS cables
◦ One 1m cable
◦ One 2m cable
◦ StoreOnce 5250 and 5650: Two 0.5m cables
Recording the iLO default network
information
Procedure
Record the iLO default network information from the
label on top of the server node.
iLO user name:________________________
iLO network name:_____________________
iLO password:_________________________
Installation prerequisites
Procedure
1. StoreOnce 5250 and 5650:
Verify that the storage
enclosure has the required front and side clearance.
The clearance is required to allow hard drive
replacement.
• At least 1,000 mm to the front
• At least 300 mm to the right of the extended
drawer
1080 mm
1000 mm
80 mm
300 mm
2.
Use rack stabilizers on racks that contain storage
enclosures.
IMPORTANT:
See the rack documentation for
detailed instructions, including safety
information, about installing units within the
rack. Ensure that you have sufficient personnel
or lifting equipment to install the storage
enclosure safely.
3. StoreOnce 5250 and 5650
: You can leave the disks
in the base enclosure during installation, but do not
add expansion disks until the storage enclosure is
installed in the rack.
Expansion disks ordered with the system are factory-
installed in the base enclosure.
CAUTION:
If the system was delivered with
further expansion disks loaded and configured,
assess the total weight. If you remove the disks
before installing to reduce weight, ensure that
they can be returned to their original
configuration. Use the supplied labels to record
the drawer and slot location of each disk.
Installing the server node and storage
enclosures in the rack - 5200
CAUTION:
Use extreme caution when installing
and pulling units from the rack. Units can slip and
fall, damaging the HPE StoreOnce System or
causing personal injury. Hewlett Packard
Enterprise is not responsible for any damage or
injury caused by mishandling the HPE StoreOnce
System.
Page 2
