8.
Install the primary PCIe riser cage.
9.
Do one of the following:
• Connect the OCP NIC 3.0 adapter cables.
•
Install a compatible transceiver option.
10. Install the system board module access panel.
11. Install the system board module in the chassis.
The installation is complete.
Example
If you want to use the OCP adapter as the iLO network interface adapter, use the Network Interface Adapter menu in the
UEFI System Utilities (
Enabling the OCP adapter as the iLO network interface adapter).
More information
Remove the system board module from the chassis
Remove the system board module access panel
Remove a PCIe riser
Installing a PCIe riser
Install the system board module access panel
Install the system board module into the chassis
Enabling the OCP adapter as the iLO network interface adapter
Procedure
1. During the server startup sequence, press the F9 key to access System Utilities.
2. From the System Utilities screen, select System Configuration > iLO 5 Configuration Utility > Network Options.
3. Select Shared Network Port – FlexibleLOM/OCP from the Network Interface Adapter drop-down menu.
4. Save the setting.
Installing the HPE NS204i-t Gen10 Plus NVMe Boot Controller option
M.2 SSD modules install on the HPE NS204i-t Gen10 Plus NVMe Boot Controller on the system board. You can install up
to two M.2 SSD modules per system board module.
HPE NS204i-t Gen10 Plus NVMe Boot Controller components.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• The components included with the hardware option kit
• T-10 Torx screwdriver
Hardware options installation
77
