7.
Disconnect all cables from the mezzanine card.
To replace the component, reverse the removal procedure.
Removing and replacing the NVMe backplane
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
that are installed on one side of the chassis must be turned 180° when they are installed on the opposite
side.
Procedure
1.
Power down the server (
on page 28).
2.
Remove the server (
on page 28).
3.
Place the server on a flat, level work surface.
4.
Remove the access panel (
on page 29).
5.
Removing and replacing an NVMe drive
on page 32).
6.
on page 29).
7.
Disconnect all cables from the NVMe backplane.
8.
Remove the NVMe backplane.
To replace the component, reverse the removal procedure.
Removing and replacing the NVMe riser
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
that are installed on one side of the chassis must be turned 180° when they are installed on the opposite
side.
Removal and replacement procedures
37
Содержание ProLiant XL230k Gen10
