To replace the component, reverse the removal procedure.
Removing and replacing an NVMe drive
IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other. Components
that are installed on one side of the chassis must be turned 180° when they are installed on the opposite
side.
Procedure
1.
Determine the status of the drive from the drive LED definitions (
NVMe drive components and LEDs
on
page 60).
2.
Back up all server data.
3.
Remove the drive:
a.
Push the Power button.
The Do Not Remove button will illuminate and flash. Do not press the button while it is illuminated.
b.
When the flashing stops and the icon on the button is no longer illuminated, press the Do Not Remove
button to release the release lever.
c.
Pull the release lever to disengage the drive from the backplane, and slide the drive out of the drive
bay.
32
Removal and replacement procedures
Содержание ProLiant XL230k Gen10
