HPE ProLiant DX190r Gen10, Руководство по техническому обслуживанию и ремонту

Страница: 75 / 130

Item LED Status Definition
4
UID button/LED
1
Solid blue Activated
• 1 flash per second = Remote
management or firmware
upgrade in progress
• 4 flashes per second = iLO
manual soft reboot sequence
initiated
• 8 flashes per second = iLO
manual hard reboot sequence
in progress
Off Deactivated
5
Do not remove LED Flashing white Do not remove the server.
Removing the server might
terminate the current operation and
cause data loss.
Off The server can be removed.
6
Health LED
1
Solid green Normal
Flashing green iLO is rebooting
Flashing amber System degraded
Flashing red System critical
3
1
When the LEDs described in this table flash simultaneously, a power fault has occurred. For more information, see
Front panel LED power fault codes on page 76.
2
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has
occurred, or the front I/O cable is disconnected.
3
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health
status.
Server UID LED
The UID LED is used to locate a particular server when it is deployed in a dense chassis with other
equipment. Activating the UID LED helps an onsite technician to quickly identify a server for maintenance
tasks.
UID button functionality
The UID button can be used to display the Server Health Summary when the server will not power on.
For more information, see the latest
HPE iLO 5 User Guide on the Hewlett Packard Enterprise website .
Component identification 75