Removing and replacing an expansion board in the
primary riser cage
CAUTION:
Before replacing a DIMM, expansion board, or other similar PCA components due to a
perceived hardware error, make sure first that the component is firmly seated in the slot. Do not
bend or flex circuit boards when reseating components.
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
on page 27.
2.
Disconnect all peripheral cables from the server.
3. Remove the server from the chassis
on page 27.
5. Remove the primary riser cage
on page 32.
6.
If the expansion board has internal cabling, disconnect these internal cables from the expansion
board.
7.
Removing an expansion board.
8.
If you do not intend to replace the expansion board, install the riser slot blank.
To replace the component, reverse the removal procedure.
Removal and replacement procedures
43
Содержание ProLiant DX190r Gen10
Страница 21: ...Customer self repair 21...
Страница 22: ...22 Customer self repair...
Страница 23: ...Customer self repair 23...
