29
Step Command
Remarks
2.
Enter Layer 3 Ethernet
interface view or Layer 3
aggregate interface view.
interface
interface-type interface-number
N/A
3.
Set the LLDP operating
mode.
•
In Layer 3 Ethernet interface view:
lldp
[
agent
{
nearest-customer
|
nearest-nontpmr
} ]
admin-status
{
disable
|
rx
|
tx
|
txrx
}
•
In Layer 3 aggregate interface view:
lldp agent
{
nearest-customer
|
nearest-nontpmr
}
admin-status
{
disable
|
rx
|
tx
|
txrx
}
By default:
•
The nearest bridge
agent operates in
txrx
mode.
•
The nearest customer
bridge agent and
nearest non-TPMR
bridge agent operate
in
disable
mode.
In Ethernet interface view,
if you do not specify an
agent type, the command
sets the operating mode
for nearest bridge agents.
In aggregate interface
view, you can set the
operating mode only for
nearest customer bridge
agents and nearest
non-TPMR bridge agents.
Setting the LLDP reinitialization delay
When the LLDP operating mode changes on a port, the port initializes the protocol state machines
after an LLDP reinitialization delay. By adjusting the delay, you c an avoid frequent initializa tions
caused by frequent changes to the LLDP operating mode on a port.
To set the LLDP reinitialization delay for ports:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Set the LLDP reinitialization
delay.
lldp timer reinit-delay
delay
The default setting is 2 seconds.
Enabling LLDP polling
With LLDP polling enabled, a device periodically searches for local configuration changes. When the
device detects a configuration change, it sends LLDP frames to inform neigh boring devices of the
change.
To enable LLDP polling:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
