HPE FlexNetwork 7500 Switch, Руководство по установке

Страница: 48 / 149

42
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see "
Attaching an ESD wrist strap ."
2.
Unpack the module and make sure the clasp is closed. Do not touch the golden plating of the
module.
Gently insert the SFP+ module into the port until it has firm contact with the slot (when the top
and bottom spring tabs catch in the slot).
If you cannot hold the module by its two sides because of high module density, press the
module on its head end to push it in.
3.
Connect the fiber to the module. For the installation procedure, see "Connecting your switch to
the network."
Figure 37 Installing an XFP/SFP+/SFP/QSFP+ module
Installing a CFP module
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
For more information, see "
Attaching an ESD wrist strap ."
2.
Unpack the CFP module. Do not touch the golden plating of the module.
3.
Holding both sides of the module, gently push the module into the slot until it has firm contact
with the slot. See
Figure 38 .
4.
Fasten the captive screws.
5.
Connect the fiber to the module. For the installation procedure, see "Connecting your switch to
the network ."
Figure 38 Installing a CFP module
(1) Gently push the module into the slot (2) Fasten the captive screws