Some switch products will specify Revision D transceivers for full support, while other products may support
earlier (older) revision transceivers – and some with specific 4x4 part numbers.
Always refer to the Datasheet or QuickSpecs for the switch product to see the current list of supported
transceivers. Refer to the compatibility tables within this document to cross-reference the Transceiver/DAC
product against the switch product to identify the minimum software required for transceiver support.
To use CLI commands to display data for an installed transceiver, see the following examples.
8400X# show int 1/10/6 transceiver
------------------------------------------------------------
Port Type Product Serial Part
Number Number Number
------------------------------------------------------------
1/10/6 QSFP+SR4 JH231A XX57nnnnnn 1990-4554
8400X# show int 1/10/6 dom
-------------------------------------------------------------------------------------------
Port Type Channel# Temperature Voltage Tx Bias Rx Power Tx Power
(Celsius) (Volts) (mA) (mW/dBm) (mW/dBm)
-------------------------------------------------------------------------------------------
1/10/6 QSFP+SR4 1 26.00 3.32 6.72 0.02, -16.99 0.58, -2.37
2 26.00 3.32 6.79 0.02, -16.99 0.59, -2.29
3 26.00 3.32 6.68 0.03, -15.23 0.59, -2.29
4 26.00 3.32 6.82 0.03, -15.23 0.60, -2.22
Aruba-5406Rzl2# show interfaces transceiver f2 det
Transceiver in F2
Interface Index : 162
Type : QSFP+SR4
Model : JH231A
Connector Type : MPO
Wavelength : 850nm
Transfer Distance : 100m (50um OM3), 150m (50um OM4)
Diagnostic Support : DOM
Serial Number : XX57nnnnnn
Status
Temperature : 33.332C
Voltage : 3.3208V
Tx Bias Rx Power Tx Power
Channel# (mA) (mW/dbM) (mW/dbM)
--------- -------- -------------- --------------
1 6.904 0.5622, -2.501 0.5822, -2.349
2 6.706 0.5922, -2.275 0.5856, -2.324
3 6.894 0.6321, -1.992 0.5813, -2.356
4 6.792 0.5111, -2.915 0.5651, -2.479
Current Alarms:
Channel 1 :
Tx bias low alarm
Rx power low warning
Channel 2 :
Tx bias low alarm
Rx power low warning
Current Errors:
Channel 1 :
Rx Loss of Signal
Channel 2 :
Rx Loss of Signal
Channel 3 :
Rx Loss of Signal
Channel 4 :
Rx Loss of Signal
Chapter 1 Overview
13