AP-310-MNT-W3
| Installation Guide
3
Figure 2
Inserting the RJ45 Cable into the Coupler
6. Connect the opposite end of the RJ45 cable to the ENET port, located on the back of the access point.
7. Once the RJ45 cable is attached, align the pins on the rear panel of the access point with the slots on the
mounting bracket. Press the button on the bottom of the mounting bracket and slide the access point
into the bracket. Release the button to secure the access point to the mounting bracket. See
Figure 3
Securing the Access Point to the Mounting Bracket
8. To lock the access point to the mounting bracket, insert the T6 Torx security screw into the hole beside
the button, located at the bottom of the mount, then tighten the screw until it is snug.
9. After the access point is securely fastened to the mounting bracket, connect the Ethernet cable to the
appropriate RJ45 coupler port on the right side of the mount.
