MF877-00 Page 3
Template Revision A
HPE instructions for this template are available at
4. Using a Phillips screwdriver, remove the two screws holding down a power supply connector
5. Repeat step 3.1.7.2 for the other power supply connector
6. Using a small adjustable wrench, remove the four hexagonal studs near the corners of the heat sink
7. Using a small adjustable wrench, remove the two small hexagonal studs that were supporting the front edge of
the middle PCA stack
8. Using a Phillips screwdriver, remove the eight screws holding down the main PCA
1. Remove the sheet metal air flow diverters from both sides of the main PCA
2. Gently remove the main PCA from the chassis (Note: The front left corner will provide resistance as
thermal material is installed under it)
9. Using a Phillips screwdriver, loosen the four screws securing the heat sink to the main PCA
10. Remove the heat sink and its backing hardware from the main PCA
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
