Lava Rock & Glass Application
Please follow the instructions below to add the finishing touch to your fire pit.
Remember the deeper your lava rock or glass the more risk of reducing if not smothering
the flame. Particular attention needs to be on the sensor assembly area- if sensor is covered,
this will cause the pit to shutdown due to smothering flame around sensor or shorting out
sensor rod.
Lava Rock Only Application
Decorative
Glass
Application
1)
Install your fire pit per instructions.
1)
Install your fire pit per instructions.
2)
Apply lava rock deep enough to
2)
Add base layer of lava rock as filler
and hide fire ring and pan- less than 2”
to enhance flame. Height should be
slightly above ring. above fire ring- use
smaller
pieces of
rock supplied on top of ring.
3)
IMPORTANT: Do not cover flame
3)
Apply top coat of glass to lava rock,
sensor with lava rock leave open. Do not again just deep enough to hide lava rock
allow any rock to touch the flame sensor rod. and pan.
4)
Flame Sensor: Do not cover flame sensor with lava rock or glass- this must
remain open. The path for gas from the sensor hood to flame sensor rod must
remain open.
12/3/2007
828
5
