Step 4—Connecting the power
1.
Close the expansion slot retention clamp to secure the card in the slot .
2.
Connect the 6-to-8 pin auxiliary power adapter cable, supplied with this kit, to the workstation
auxiliary power supply
2
, and then to the FX5800 card .
NOTE:
No connection is made at point . If a label covers the outlet at , do not remove it.
Figure 6
Installing the 6-to-8 pin power adapter cable
Step 5—Installing the card support
HP xw8600 and xw9400 Workstations
To prepare and install the card support bracket:
1.
Insert an additional arm in the card support , if applicable.
2.
Slide the arm back to lock it into place
2
.
3.
Hook the support bracket in the openings along the edge of the rear of the chassis .
4.
Compress the spring of the support arm until the arm locks into place .
Figure 7
Installing a card support (HP xw8600 and xw9400 Workstations)
ENWW
Step 4—Connecting the power
7
