HP XP, Руководство пользователя

Страница: 12 / 148

2 Environmental Prerequisites
System configuration
The system configuration requirements for VSS Provider are shown below.
•
The HPE VSS Hardware provider must be installed on both the backup and recovery
application server (such as the media server in a Symantec NetBackup environment) and
the application server (such as a Microsoft Exchange server) from which a backup will be
taken.
•
Table 1 (page 12) shows the connection of I/O path between servers and disk array systems
and the connection that VSS Provider gives an operation direction to the disk array systems
for FC environment support.
•
In the case of XP P9500/XP7, the command device must be mapped on an application
server and a backup server.
•
IPv6 is not supported.
•
Fiber channel switches are not always required. Use them according to your environment
as needed.
•
Multiple disk array systems can be connected to both an application server and a backup
server.
•
For the application server, a cluster configuration using MSCS (MSFC) is also possible. (For
the backup server, this configuration is impossible.)
•
The necessity of using the same operating system on both the backup server and the
application server depends on the backup software.
Table 1 Server and disk array systems connection
Connection between servers/disk array systems for
FC environment
Path for an operation
direction I/O path Host port Disk array system
Must be connected with FC Must be connected with FC FC XP P9500/XP7
Examples of supported system configurations
VSS Provider supports the following system configurations.
Figure 3 (page 13) shows a similar configuration using a XP P9500/XP7 disk array system.
12 Environmental Prerequisites