HP Workstation x4000, Руководство по установке аксессуаров

Страница: 49 / 54

Installing Accessories
Processor
Chapter 2 47
Installing a Processor
To install a processor:
1. Turn off the display and shut down the Workstation. Disconnect all
power cables and any LAN or telecommunications cables.
2. Remove the Workstation’s cover (see page 15).
3. Place the Workstation on its side for better access.
4. Open the hard disk drive cage (see page 19).
5. Remove the Chassis Beam Assembly (see page 22).
6. Remove the MEC card (see page 32).
7. Ensure the processor is correctly oriented by matching the notches on
the processor to the notches on the ZIF socket. Then carefully lower
the new processor into place. When the processor is fully inserted,
close the ZIF lever.
CAUTION Be extremely careful when you insert the processor. If you bend one of
the pins, it will not go into the socket.
Figure 2-22 Inserting a Processor
8. Affix the new thermal interface material, provided with the new
processor, to the top of the processor.
9. Attach the heatsink to the processor. Use the retaining clips to attach
the heatsink. For easier installation, partially attach both clips by
hooking one end of the side slot in each clip. Press down on the
remaining ends of both clips until they click into place.
Step 7
Step 9
This manual downloaded from http://www.manualowl.com