HP t310 G2, Инструкция по разборке, Страница: 2 / 9

EL-MF877-00 Page 2
Template Revision A
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description Tool Size (if
applicable)
Description #1: Flat Blade Screwdriver 5mm
Description #2: Phillips Screwdriver #1
Description #3 3/16” Hex Nut Driver 3/16”
Description #4
Description #5
Description #6
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Loosen 4 screws from the Rear Cover
2. Dis-assemble the Rear Cover with Tools
3. Loosen these four Screws from the Panel
4. Pull out the Connector of Back Light/LVDS FFC and Take out OSD Board
5. Loosen these four Screws from the Middle Frame in order to Dis-Assemble the Front Bezel
6. Loosen these 12 Screws from the Middle Frame in order to Dis-Assemble the Middle-Frame
7. Loosen the 2 Screws from the Bottom side of Metal Frame
8. Pulling out the Cables of the SPK and Loosen the 5 screws in order to take out the assembly of the MB
9. Pulling out Assy-SPK from the Assy-Metal Bracket
10. Pulling out the Cable of the LVDS,OSD Board and BackLight
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).