HP Surestore 80ex - Optical Jukebox, Руководство пользователя

Страница: 24 / 96

1-12 Chapter 1
Setting up the Jukebox
Moving or Shipping the Optical Jukebox
Moving or Shipping the Optical Jukebox
To move the jukebox a short distance, such as to another office or to another floor in
your building, refer to “Moving the Jukebox”. To ship the jukebox to another
location, refer to “Shipping the Jukebox”.
Moving the Jukebox a Short Distance
1. Unmount any optical disk surfaces in the jukebox if necessary.
See your computer operating system, or software application documentation for
instructions on how to unmount optical disks.
2. Ensure that there are no disks in the drives.
Eject any disks as necessary. Refer to your jukebox application software
documentation. If you will be manually ejecting disks, refer to “Ejecting an
Optical Disk from the Jukebox” on page 3-10.
CAUTION
Failure to eject a disk from the optical drive prior to moving the jukebox could result
in damage to the optical drive mechanism.
CAUTION
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive.
Removing power from a SCSI peripheral when the bus is active can result in data
loss and/or indeterminate bus states. Check your host system manuals for
information about checking the SCSI bus status. If your computer is connected to a
LAN, be sure to check with your system administrator before turning off power to
the jukebox.
3. Switch jukebox power OFF (see “3” on Figure 1-1). The power switch is OFF
when it is out.
4.
Remove the power cord and the SCSI cable connections from the rear of
the jukebox.
5. Carefully move the jukebox to its new destination. If the jukebox contains disks,
do not tip the jukebox or lay it on its side.
6.
Set up the jukebox at its new location, following the procedures in the
beginning of this chapter.