HP StoreFabric SN6500B, Руководство администратора

Страница: 71 / 108

Access Gateway Administrator’s Guide 51
53-1002743-01
Failover policy
3
Failover configurations in Access Gateway
The following sequence describes how a failover event occurs:
•
An N_Port goes offline.
•
All F_Ports mapped to that N_Port are temporarily disabled.
•
If the Failover policy is enabled on an offline N_Port, the F_Ports mapped to it will be
distributed among available online N_Ports. If a secondary N_Port is defined for any of these
F_Ports, these F_Ports will be mapped to those N_Ports. If the Port Grouping policy is enabled,
then the F_Ports only fail over to N_Ports that belong to the same port group as the originally
offline N_Port.
Failover example
The following example shows the failover sequence of events in a scenario where two fabric ports
go offline, one after the other. Note that this example assumes that no preferred secondary N_Port
is set for any of the F_Ports.
•
First, the Edge switch F_A1 port goes offline, as shown in Figure 11 on page 52 Example 1
(left), causing the corresponding Access Gateway N_1 port to be disabled.
The ports mapped to N_1 fail over; F_1 fails over to N_2 and F_2 fails over to N_3.
•
Next, the F_A2 port goes offline, as shown in Figure 11 on page 52 Example 2 (right), causing
the corresponding Access Gateway N_2 port to be disabled.
The ports mapped to N_2 (F_1, F_3, and F_4) fail over to N_3 and N_4. Note that the F_Ports
are evenly distributed to the remaining online N_Ports and that the F_2 port did not participate
in the failover event.