HP StoreFabric CN1100R, Руководство пользователя

Страница: 5 / 32

Introduction 5
Introduction
Overview
The StoreFabric CN1100R 2P CNA is a dual-port converged network adapter that supports Gen8 ML and
DL ProLiant servers and uses the Broadcom 57810s Meru-D.
For more information about the StoreFabric CN1100R 2P CNA, see the Hewlett Packard Enterprise
website ( http://www.hpe.com/info/cna ).
Downloading files
1.
Go to the Hewlett Packard Enterprise website ( http://www.hpe.com/info/cna ).
2.
Select the adapter.
3.
Select Technical Support/Manuals , and then select Drivers, Software & Firmware .
4.
Download the drivers and firmware as needed.
Installation prerequisites
Before you begin, be sure the following items are available:
•
An optical multi-mode cable with an LC-style duplex connector and approved SFP+ module or
copper cable
•
A server with an empty x8 PCIe bus slot
WARNING: Disconnect the host from the power source before installing the CNA.
Recording reference numbers
The CNA ships with the IEEE address (Port 1 MAC address) clearly marked on the board.
The MAC address is a unique, 48-bit identifier for configuring the system. The Fibre Channel industry
uses the WWN derived from the MAC address for Fibre Channel connectivity. The MAC addresses are
permanent identifiers that cannot be changed.
The CNA has two ports, so it has two MAC addresses and two WWNs, one for each port. Use the serial
number when communicating with Hewlett Packard Enterprise. Determine and record the serial number,
MAC addresses, and WWNs before installation.
Identifier Port 1 Port 2
MAC address
(From IEEE address label)
AC-16-2D-83-00-B0
Port 1 MAC address:
(Port 1 MAC a 4)
AC-16-2D-83-00-B4
Port 2 MAC address:
WWN
(20:00:[Port 1 MAC a1])
20:00:AC-16-2D-83-00-B1
Port 1 WWN:
(20:00:[Port 2 MAC a1])
20:00:AC-16-2D-83-00-B5
Port 2 WWN: