HP StorageWorks DLT80, Справочное руководство

Страница: 45 / 74

Operating the DLT80 Tape Drive
45 DLT80 Tape Drive Reference Guide
Table 4 shows the results of density selection.
Density Select Example
If a cartridge with a prerecorded 20.0 density has been loaded and the Density
Select button was pressed to select 35.0 density:
■
The 20.0 LED remains illuminated pending the change in density.
■ The 35.0 LED flashes indicating a change in density is pending.
■
The Density LED illuminates.
When the write from BOT occurs:
■ The 20.0 LED shuts off.
■ The 35.0 LED changes to on.
■
The Density LED remains illuminated.
Table 4: Results of Density Selection
If Then
The Density Select button
wasn't pressed,
The LEDs show the actual density when the
cartridge is reading and writing. The LEDs are
illuminated steadily and Density LED is off.
The Density Select button
was pressed, and if the
actual cartridge density is
the same as the density
selected,
The actual density and the Density LEDs are
illuminated. For example, if the actual cartridge
density is 20.0 and the selected cartridge density
is 20.0, then the 20.0 LED will be illuminated.
The Density Select button
was pressed, and if the
actual cartridge density
differs from the density
selected,
1. The LED with the actual density is illuminated
steadily.
2. The LED with the selected density blinks.
3. Density LED is illuminated steadily.
For example, if the actual cartridge density is 35.0
and the selected density is 20.0, the 35.0 LED is
illuminated steadily, the 20.0 LED blinks, and the
Density LED is illuminated steadily.