2.
Install three screws on each side of the bracket.
3.
Attach a spacer to the front caster plate. Center the spacer
approximately 2.54 to 7.62 cm (1.00 to 3.00 in) behind the
front edge of the caster plate. Apply pressure to adhere the
spacer to the caster plate.
Installing a support bracket riser
To install the component:
1.
Place the riser on top of the support bracket, aligning the
mounting holes.
2.
Secure the riser to the support bracket with the provided self-
tapping screws.
The installation is complete.
Attaching a spacer to an
enclosure installed below an
SSA70 or MDS600
If the SSA70 or MDS600 is being installed in the rack directly above
a c3000 or c7000 enclosure, a spacer must be adhered to the top
of the c3000 or c7000 enclosure.
IMPORTANT:
Do not attach the spacer to an SSA70 or
MDS600 unit.
1.
Remove the protective backing from the spacer.
2.
Center the spacer approximately 2.54 to 7.62 cm (1.00 to
3.00 in) behind the front edge of the enclosure. Apply pressure
to adhere the spacer to the enclosure.
IMPORTANT:
Do not cover any labels on the enclosure
when attaching the spacer.
Installing a support tray
1.
Install two clip nuts on each side of the front and rear of the
rack at the top and bottom of a 1U space.
2.
Install each rear side bracket using two screws. Do not fully
tighten the screws. L (left) and R (right) markings indicate the
correct side for installation when viewed from the front of the
rack. The support pin should be facing inward.
3.
Insert the support tray into the rack front.
4.
Set the support tray on the support pins on the rear side
brackets.
5.
Install four screws to secure the front of the support tray to the
rack, and then tighten all four front screws.
6.
Install two screws through the rear of the support tray into the
threaded inserts on the rear side brackets, and then tighten all
screws.
7.
Center the spacer approximately 2.54 to 7.62 cm (1.00 to
3.00 in) behind the front edge of the support tray. Apply
pressure to adhere the spacer to the support tray.