HP storageworks 2/32, Руководство по установке

Страница: 55 / 138

Installing and Configuring the Edge Switch 2/32
55 Edge Switch 2/32 Installation Guide
Configure Switch Operating Parameters
Use the procedures in this section to set parameters on the switch for fabric
operation through the
Configure Switch Parameters dialog box. These operating
parameters are stored in NVRAM on the switch.
1. The switch must be offline to change Preferred Domain ID and other
operating parameters. Ensure the switch is set offline. For instructions, see
“ Set the Switch Offline ” on page 52.
Caution: Setting the switch offline terminates all Fibre Channel connections.
2. Choose Configure > Operating Parameters > Switch Parameters . The
Configure Switch Parameters dialog box displays ( Figure 16 ).
Figure 16: Configure Switch Parameters dialog box
Note: Ordinarily, you do not need to change values in this dialog box from their
defaults. The only exception is the Preferred Domain ID. Change this value if the switch
will participate in a multiswitch fabric.
3. Use information in the “ Switch Parameters ” section, which follows, to change
settings as required for parameters in this dialog box.
4. After you change settings, click the Activate button.
5. Set the switch online. For instructions, see “ Set the Switch Online ” on
page 52.