Remove the speaker connector boards:
1.
Release the ZIF connector
(1)
to which the left speaker connector board cable is attached, and
then disconnect the left speaker connector board cable from the system board.
2.
Remove the three Torx T5M1.3×3.7 screws
(2)
that secure the left speaker connector board to
the back cover.
3.
Remove the left speaker connector board
(3)
.
NOTE:
If the power
(1)
and volume board actuators
(2)
should become displaced during the
removal of the left speaker connector board, install the actuators into the openings in the back
cover as indicated in the following illustration. The power and volume board actuators are
included in the back cover spare part kit, spare part number 776015-001.
22
Chapter 5 Removal and replacement procedures
Содержание Slate 10 Plus
Страница 4: ...iv Safety warning notice ...
