HP ProLiant XL230a Gen9, Руководство пользователя, Страница: 36 / 80

Hardware options installation 36
6.
Install the expansion board into the slot until it seats firmly.
7.
Connect and route all drive cables. For more information, see "Drive cabling (on page 44 )."
8.
Install the PCI riser board assembly (on page 19 ).
IMPORTANT: The server does not power up if the PCI riser board assembly is not seated
properly.
9.
Install the server into the chassis (" Install the server " on page 19 ).
10.
Connect all peripheral cables to the server.
11.
Press the Power On/Standby button.
The server powers down and enters standby mode. The system power LED changes from green to
amber. Power is still applied to the server.
Processor option
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor
configurations must contain processors with the same part number.
To remove the component:
1.
Update the system ROM.
Locate and download the latest ROM version from the HP website Follow the instructions on the website to update the system ROM.
2.
Power down the server (on page 13 ).
3.
Disconnect all peripheral cables from the server.
4.
Remove the server (on page 14 ).
5.
Place the server on a flat, level work surface.
6.
Remove the processor air baffle (on page 15 ).