HP ProLiant SL250s Gen8, Руководство пользователя, Страница: 16 / 119

Operations 16
Operations
Power down the server
Before powering down the server for any upgrade or maintenance procedures, perform a backup of critical
server data and programs.
IMPORTANT: When the server is in standby mode, auxiliary power is still being provided to the
system.
To power down the server, use one of the following methods:
•
Press and release the Power On/Standby button.
This method initiates a controlled shutdown of applications and the OS before the server enters standby
mode.
•
Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter
standby mode.
This method forces the server to enter standby mode without properly exiting applications and the OS.
If an application stops responding, you can use this method to force a shutdown.
•
Use a virtual power button selection through iLO 4.
This method initiates a controlled remote shutdown of applications and the OS before the server enters
standby mode.
Before proceeding, verify the server is in standby mode by observing that the system power LED is amber.
Remove the server from the chassis
1.
Power down the server (on page 16 ).
2.
Disconnect all peripheral cables from the server.
CAUTION: To avoid damage to the server, always support the bottom of the server when
removing it from the chassis.
3.
Remove the server from the chassis:
a.
Press the release button on the front of the server, and then extend the tray handle.
b.
Press the release button on the side of the server.