HP ProLiant ML350 Gen9, Руководство по техническому обслуживанию и ремонту

Страница: 34 / 124

Removal and replacement procedures 34
o
For rack models, if installed, remove the security bezel (" Remove the security bezel (optional) "
on page 28 ).
2.
Power down the server (on page 29 ).
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Do one of the following:
o
For tower models, place the server on a flat, level surface with the access panel facing up.
o
For rack models, extend the server from the rack (on page 29 ).
5.
If a Kensington security cable is installed, disconnect it from the rear panel. See the security cable
documentation for instructions.
6.
Open the access panel latch, slide the access panel to the rear of the chassis, and then remove the
access panel.
If the access panel latch is locked, use a T-15 Torx screwdriver to unlock the latch.
To replace the component, reverse the removal procedure.
Drive blank
To remove the component:
1.
Do one of the following:
o
For tower models, open and remove the tower bezel (on page 28 ).
o
For rack models, if installed, remove the security bezel (" Remove the security bezel (optional) "
on page 28 ).