Installing a 3.5-inch device (model 400)
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 42
).
2.
Remove the access panel (
Access panel on page 43
).
3.
Remove the front bezel (
Front bezel on page 44
). Remove the front bezel. If you are installing a
drive in a bay covered by a bezel blank, remove the bezel blank.
4.
Slide the device into the drive bay (1) and install the two 6-32 mounting screws in the side of the
device (2) to secure it in place.
NOTE:
HP has supplied extra 6-32 mounting screws on the front of the chassis behind the bezel.
Refer to
Drives on page 59
for an illustration of the extra mounting screws location.
When replacing a device, use the two 6-32 mounting screws that were removed from the old
device to install the new one.
Drives
67