HP ProCurve Series 2810, Руководство по управлению и настройке

Страница: 185 / 420

Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
2. Press [E] (for
Edit
). The cursor moves to the
Enabled
field for the first port.
3. Refer to the online help provided with this screen for further information
on configuration options for these features.
4. When you have finished making changes to the above parameters, press
[Enter]
, then press [S] (for
Save
).
CLI: Viewing Port Status and Configuring Port
Parameters
Port Status and Configuration Commands
show interfaces brief below
show interfaces config page 10-8
interface page 10-10
show spanning tree page 10-9
From the CLI, you can configure and view all port parameter settings and view
all port status indicators.
Using the CLI To View Port Status
Use the following commands to display port status and configuration:
■ show interfaces brief : Lists the full status and configuration for all ports
on the switch.
■
show interface config
: Lists a subset of the data shown by the
show
interfaces
command (above); that is, only the enabled/disabled, mode, and
flow control status for all ports on the switch.
Syntax : show interfaces [ brief | config ]
These two commands display the information listed in
table 10-2, below.
Table 10-2. Comparing the "Show Interfaces” Command Options*
Feature Show Interfaces Brief Show Interfaces Config
Port Number and Type Yes Yes
Enabled Y/N Yes Yes
Flow Control Yes Yes
Status Up/Down Yes No
Mode (Operating) Yes No
Intrusion Alert Yes No
10-7