HP MSM760 Controllers Quickstart
This document describes how to install the MSM760 Access Controller (J9421A), and the MSM760 Premium
Mobility Controller (J9420A). These products are hereafter referred to as controller. The controller works
with HP 802.11n and 802.11ac access points to deliver a high-performance networking solution. For a list
of supported APs, see the HP MSM7xx Controllers Release Notes.
For additional installation information, and instructions on how to initially configure the controller, see the
HP MSM760 Controllers Installation Guide.
Hardware overview
Figure 1 MSM760 front view
1
2
3
4
5
6
7
5. Keypad (not used)
1. Power, Fault, and Locator LEDs
6. USB port (not used)
2. Ethernet Ports: 1=Internet, 2=LAN
7. Ethernet LEDs
3. Console port
4. LCD display
Package contents
Controller, console cable, two mounting brackets, eight 8 mm screws, four 5/8 inch screws, four rubber
feet, power cord, and documentation.
LCD display
The LCD displays the following:
•
The controller type, either
Mobility Controller
or
Access Controller
.
•
The maximum number of supported APs, as defined by the installed license.
•
The IP address of the Internet port. (Until the controller receives its IP address from a DHCP server, the
address displays as:
0.0.0.0)
During start up, the LCD displays a system booting message.
*5998-7942*
© Copyright 2014, 2015 Hewlett-Packard Development Company, L.P.
Printed in China
The information in this document is subject to change without notice.
HP Part Number: 5998-7942
Published: June 2015
Edition: 1