HP ProCurve 8116fl, Руководство по установке и началу работы

Страница: 61 / 134

3
Getting Started With Switch Configuration
This chapter is a guide for using the command line interface (CLI) via a direct
console to quickly assign an IP address and subnet mask to the switch, set a
Manager password, and, optionally, configure other basic features.
Topics covered in this chapter include:
■
Accessing the CLI (see page 3-1 )
■ Setting Basic System Information (see page 3-2 )
■
Setting up Passwords (see page 3-6 )
■ Updating Software (see page 3-10 )
N o t e
Many other features can be configured through the CLI to optimize the
switch’s performance, enhance your control of network traffic, and improve
security. Once an IP address has been configured on the switch, these features
can be accessed more conveniently through a remote Telnet session. For more
information, refer to the
Management and Configuration Guide which is on
the Documentation CD-ROM that came with your switch.
Booting Up and Accessing the CLI
1. Connect a terminal device to the switch as described on page 2-27 .
2. Power on the switch by either inserting the power supplies or turning on
the AC to the power supplies.
3. At the prompt, press Enter to activate the Command Line Interface (CLI)
on the console.
N o t e
If the boot sequence stops and the CLI presents a bootrom prompt
(
PMON> ), call ProCurve Networking technical support.
4. From the Exec mode prompt (for example,
Switch 8100fl>
) type
enable
and
press Enter.
The prompt will change to the Privileged Exec prompt (
Switch 8100fl#
)
and you now have full access to the CLI. (For information on all of the CLI
modes, refer to the
Management and Configuration Guide .)
Get
tin
g S
ta
rte
d
With
S
w
itch
Co
nfi
gurati
o
n
3-1