HP ProCurve 1600M, Руководство по управлению и настройке

Страница: 449 / 690

Redundancy (Switch 8212zl)
Displaying Management Information
Show Version
The
show version
command displays system software image information for
both management modules as well as which module is the active management
module and which is the standby management module. The Boot Image field
displays which flash image last booted from, even if the
boot set-default
command has been set to change the flash booted from on the next boot. The
output of the
show version
command when redundancy is enabled is shown in
Figure 15-16.
ProCurve(config)# show version
Management Module 1: Standby
Image stamp: /sw/code/build/btm(t2g)
Mar 5 2007 13:20:59
K.12.XX
351
Boot Image: Primary
Management Module 2: Active
Both management
Image stamp: /sw/code/build/btm(t2g)
modules were booted
Mar 5 2007 13:20:59
from primary flash.
K.12.XX
351
Boot Image: Primary
Figure 15-16. Example of Show Version Command when Redundancy is Enabled
When redundancy is disabled, the output of the show version command
changes, as shown in Figure 15-17.
ProCurve(config)# show version
Management Module 1:
Redundancy and Synchronization has been disabled:
enable with the ‘redundancy’ command.
Management Module 2: Active
Image stamp: /sw/code/build/btm(t2g)
Mar 5 2007 13:20:59
K.12.XX
351
Boot Image: Primary
Figure 15-17. Example of show version Command when Redundancy is Disabled
15-25