HP Pavilion x360 m1-u000, Руководство по техническому обслуживанию и ремонту

Страница: 50 / 90

Solid-state drive
Description Spare part number
128-MB, M2.2280 solid-state drive (DRAM-less; for use only on computer models equipped with an Intel
Core processor) 827560-011
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see Keyboard/top cover on page 32 ).
5. Disconnect the battery cable from the system board (see Battery on page 39 ).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the solid-state drive to the computer. (The solid-
state drive tilts up.)
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
42 Chapter 5 Removal and replacement procedures